Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 7921
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to add variable in Model file and Control the variable from ADE

AmarDas

Hi,

I am trying to add a variable in the model file, then control it from the ADE design variable.

I have gone through these posts(post1 and post2), unfortunately non of them are helping because I am trying to define a variable inside a model device parameter.

model nch_device bsim4 {
1: type=n
+lmin=8.973e-006-dxln_40
+lmax=900.01e-006 wmin=9e-006-dxwn_40
+wmax=900.01e-006 version=4.5
+toxref=3e-009  vth0=0.57213+dvthn_40+MY_VARIABLE 
}

It doesn't seem to be working for me. Any help ?

Regards,

Amar

Parents
  • Andrew Beckett

    Amar,

    That should work. I just did this and it worked perfectly.  What's not working?

    Andrew

Reply
  • Andrew Beckett

    Amar,

    That should work. I just did this and it worked perfectly.  What's not working?

    Andrew

Children
  • AmarDas
    in reply to Andrew Beckett

    Hi Andrew,

    Thank you for your help.

    I had to play with length and width, since there were multiple if loop for them. It worked at the end when I add the variable in correct loop.

    I will delete this post, since it no use for future.

    Regards,

    Amar

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.