Stats

  • Locked Locked
  • Replies 2
  • Subscribers 126
  • Views 6603
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Plot the results of only one test in ADE Assembler

Zol

Is there a way to plot the results of only one test in ADE Assembler? I run multiple test parallel, but I would like to go over the results one by one (I have to look into the waveforms as well) The Plot All option plots the defined output results for all the tests. Even if I use filters or hide all other test in the Results tab.

Parents
  • Andrew Beckett
    Zol said:
    Is there a way to plot the results of only one test in ADE Assembler?

    There isn't a "plot all" for the whole of a single test, although I can see that would be useful. I did a quick search and didn't find any requests for this, but I didn't look that carefully - so I may have missed requests.

    What might work well is to take advantage of the Select which tests are displayed in the table drop-down in the toolbar, and then add a "Plot All Displayed Tests" in the drop-down for Plot All. I can see that as a reasonable use model - but obviously this needs an enhancement. I would suggest that you contact customer support (create a support case on the portal) and reference this forum discussion.

    Regards,

    Andrew

Reply
  • Andrew Beckett
    Zol said:
    Is there a way to plot the results of only one test in ADE Assembler?

    There isn't a "plot all" for the whole of a single test, although I can see that would be useful. I did a quick search and didn't find any requests for this, but I didn't look that carefully - so I may have missed requests.

    What might work well is to take advantage of the Select which tests are displayed in the table drop-down in the toolbar, and then add a "Plot All Displayed Tests" in the drop-down for Plot All. I can see that as a reasonable use model - but obviously this needs an enhancement. I would suggest that you contact customer support (create a support case on the portal) and reference this forum discussion.

    Regards,

    Andrew

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.