• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. issue with assembler running corner simulations

Stats

  • Locked Locked
  • Replies 1
  • Subscribers 125
  • Views 5854
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

issue with assembler running corner simulations

greywanderer
greywanderer over 2 years ago

Hi,

 

When running corners sims in assembler the process seems to be stuck at the end of the current simulation, even though the simulation log shows that its done, and waits for 5min before moving to the next sim. Below is the snapshot of the job log.

 

[2023-04-05 09:08:22.962 -0500] [PROCESS] [cadence.virtuoso.ade.spectreMonitor] - Finished Simulation : {"hostname": "xxxxxx", "processid": 1461020, "history": "Interactive.38", "testname": "xxxx", "cornername": "Cff_ht", "point": 3, "logfile": " xxxx/logs0/Job38.log ", "simid": "4"}

[2023-04-05 09:13:17.098 -0500] [PROCESS] [cadence.virtuoso.ade.spectreMonitor] - Launched evaluator : {"hostname": "xxxxxx", "processid": 1461020, "history": "Interactive.38", "testname": "xxxx", "cornername": "Cff_ht", "point": 3, "logfile": "xxxx/logs0/Job38.log"}

 

What could be the issue here?

Thanks!

  • Cancel
  • Andrew Beckett
    Andrew Beckett over 2 years ago

    Not really enough information to go on, but in practice I'd say debugging this via the forums is not going to be very effective. Please contact customer support - that's what it's for.

    Andrew

    • Cancel
    • Vote Up +1 Vote Down
    • Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information