• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Unable to select pins in layout

Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 7526
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unable to select pins in layout

andrewevery
andrewevery over 2 years ago

I'd like to select some pins so I can move them. However, clicking on them, whether in the layout, navigator, or schematic, does not select them in the layout. All layers and objects are set to be selectable in the palette. What am I doing wrong? I'm using IC6.1.7-64b.78.

  • Cancel
Parents
  • Andrew Beckett
    Andrew Beckett over 2 years ago

    Perhaps use Window→Assistants→Dynamic Selection and then hover over the pin - you can then check if it's on a different layer-purpose. If unselectable, it will be in italics. I did wonder whether you might have used Selection Protection (under Edit->Select) but normally that would show with a halo around the protected shapes.

    Andrew

    • Cancel
    • Vote Up +1 Vote Down
    • Cancel
  • andrewevery
    andrewevery over 2 years ago in reply to Andrew Beckett

    Thank you so much! Somehow the purpose was set to gapfill, I changed it in the pin placement window and now I can select the pins again.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • andrewevery
    andrewevery over 2 years ago in reply to Andrew Beckett

    Thank you so much! Somehow the purpose was set to gapfill, I changed it in the pin placement window and now I can select the pins again.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information