Stats

Locked Locked
Replies 3
Subscribers 125
Views 6891
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ams simulation does not work

Hello,
After setting up my maestro (let's call it maestro1) and changing the simulation with ams, a warning window popped up.
Unfortunately, I did not save this warning window.
My hazy memory tells me that the message is more or less like this message below that I got from CIW:

I ignored the window and went through the simulation.
But somehow no results in result browser.
No error message in xrun log.
Netlist can still be created.

I have other maestro (let's call it maestro2) file which uses ams.
I tried to simulate it again, it works.

Then, I created a new test on maestro1 using the design/config from maestro2.
The same problem happens.

Is there anything that I can check?

Virtuoso IC6.1.8-64b.500.14
Xcellium 20.09-s001
Spectre 19.1.0 64bit

EDIT:
The window pops up again after restarting Virtuoso and openning maestro1.

Parents

Andrew Beckett over 2 years ago

I don't believe this is anything to do with that warning; that's a warning about properties in the config (which aren't required in general). There was some work in ISR19 (after the version you're using) to clean up the unnecessary warning.

I suggest you contact customer support - hard to know what it is without seeing more details.

Andrew
Cancel
Vote Up 0 Vote Down

Cancel
delgsy over 2 years ago in reply to Andrew Beckett

Hi Andrew, I uploaded the message windows that I did not save previously.
Cancel
Vote Up 0 Vote Down

Cancel
Andrew Beckett over 2 years ago in reply to delgsy

Presumably this is referenced via the Setup→Connect Rules/IE Setup, and you need to to reference the library in your cds.lib. Perhaps you could share what it shows on the Connect Rules/IE Setup form (although if you redact everything it's quite hard to know if it's correct or not).

However, since you posted another post later, perhaps this part is resolved?

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 2 years ago in reply to delgsy

Presumably this is referenced via the Setup→Connect Rules/IE Setup, and you need to to reference the library in your cds.lib. Perhaps you could share what it shows on the Connect Rules/IE Setup form (although if you redact everything it's quite hard to know if it's correct or not).

However, since you posted another post later, perhaps this part is resolved?

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.