• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. IC design

Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 5580
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IC design

liangqunshan
liangqunshan over 2 years ago

I found an interesting phenomenon. I called two modules in a schematic diagram and inserted a device (as shown in the following figure) to connect them. in the layout suite XL editing interface, after setting “options-display-nets” option, the connection relationship between one module and this device is prompted, while the other does not. Why does this happen?

  • Cancel
  • Guangjun Cao
    Guangjun Cao over 2 years ago

    Does the transistor have a gate contact on your layout?

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
  • liangqunshan
    liangqunshan over 2 years ago in reply to Guangjun Cao

    Yes ,it does !

    As shown in the following figure.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information