Home
  • Products
  • Solutions
  • Support
  • Company

This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • Products
  • Solutions
  • Support
  • Company
Community Custom IC Design Showing OP in ADE Explorer

Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 5021
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Showing OP in ADE Explorer

ncallens
ncallens over 1 year ago

Dear Forum, 

I tried to look up if somebody had the same problem, but it seems not. Therefore, I wanted to ask if someone has experienced the same problem with showing the OP parameters in ADE Explorer: I can only see the following parameters (so not "region", "vgt", etc.). Is this problem related to the model files of the tech? I am currently using 6.1.8.

Kind regards, 

Nicolas

  • Cancel
Parents
  • Andrew Beckett
    Andrew Beckett over 1 year ago

    Hi Nicolas,

    My guess is that your PDK has subckt models and has the opParamExprList set in the CDF for a device, which maps a limited set of operating point parameters from an underlying device within the subckt to the symbol representing the subckt. You should be able to see this by using Tools→CDF→Edit in the CIW, picking the device in question, and then looking at the Simulation Information tab for Spectre as the simulator.

    Andrew

    • Cancel
    • Vote Up +2 Vote Down
    • Cancel
Reply
  • Andrew Beckett
    Andrew Beckett over 1 year ago

    Hi Nicolas,

    My guess is that your PDK has subckt models and has the opParamExprList set in the CDF for a device, which maps a limited set of operating point parameters from an underlying device within the subckt to the symbol representing the subckt. You should be able to see this by using Tools→CDF→Edit in the CIW, picking the device in question, and then looking at the Simulation Information tab for Spectre as the simulator.

    Andrew

    • Cancel
    • Vote Up +2 Vote Down
    • Cancel
Children
  • ncallens
    ncallens over 1 year ago in reply to Andrew Beckett

    Hi Andrew,

    Indeed, this is the case. I think I will have to ask the CAD manager to change this (since it is read-only). Thanks for point this out.

    Kind regards,

    Nicolas

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information