Stats

  • Locked Locked
  • Replies 1
  • Subscribers 125
  • Views 5214
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Autostop in Maestro after evaluating all measurements

Ejcxuralsshdd

Hi

I have over 80 measuremnts inside Maestro. I want to stop given transient run after it has calculated all 80 measurements. 

As per my knowlege, Spectre autostop only on event condition. One of the way to do this is using MDL. But i never personally used SpectreMDL and i dont know if Maestro expressions syntax are valid in Spectremdl.

Can someone suggest best approach to solve my issue ?

Thanks

  • This doesn't make any sense. The expressions in the maestro view are evaluated after the simulation has finished, so there's nothing to stop let alone auto-stop. If you need the simulation to stop, then you'd have to use SpectreMDL (no, maestro expressions are no the same syntax), or you'd need to do your checks in a Verilog-A module which could call $finish_current_analysis() when the condition to stop is met.

    Andrew

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.