Monte-Carlo mean included in expressions

Svilen,

Assuming you have an existing expression for the particular measurement you want, say called existing_measurement, you can add another output and set the evalType column to "sweeps" (this will measure across the Monte Carlo sweep). The expression can then be:

average(existing_measurement ?continuous nil ?overall t)

The ?overall t should get added automatically to the expression when you change the evalType to sweeps.

Andrew

Andrew, thanks for replying. Let's see if I understood what you are saying.

I have defined an expression Gain for which I want to obtain the mean value out of MC simulation.
If I understood well, you are saying I should define another expression, say Gain_avg, for which I set the evalType to sweep and define that Gain_avg as

average(Gain ?continuous nil ?overall t)

Have I got it right?

Svilen

Svilen64 said:

Have I got it right?

Yes, spot on.

Andrew

Svilen64 I assume you spotted the typo (I was about to point it out) and then deleted the post - presumably you got it working.

Andrew

Yes, I spotted the typo and deleted the message because of that, thinking that was the reason it was not working. But even after correcting it, I still couldn't get it to work. Simulations go fine, it just doesn't evaluate that specific expression at the end.

Svilen

Yes, I spotted the typo and deleted the message because of that, thinking that was the reason it was not working. But even after correcting it, I still couldn't get it to work. Simulations go fine, it just doesn't evaluate that specific expression at the end.

Svilen