Stats

  • Locked Locked
  • Replies 0
  • Subscribers 125
  • Views 4041
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

calcVal ?matchParams to model file section

MatanR

Hello.

I'm trying to run a calibration simulation in ADE.

1. Calibration test corners are different by their specific section used from the process model file.

2. Validation test corners are same as calibration but also include a variable sweep

3. due to internal variable sweeps in corner setup - several corners are generated with a suffix (for example if I sweep variable "var" in a corner called "typ" with values "a" and "b" - I get two corners generated "typ_0" and "typ_1").

I with to use calcVal to draw the right calibration test corner - my test assumes they will have the same section from the process model file (everything else is different).

I do not know how to make ?matchParams to check the model files (I know we can do ?ignoreParams "modelFiles" - but ?matchParams requires a value).

Thank you,

Matan.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.