Stats

Locked Locked
Replies 2
Subscribers 125
Views 4375
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pegasus DRC Run fails

While running DRC using Pegasus in Cadence Virtuoso:

"ERROR (XSTRM-321): Translation cannot be continued as the '-enableColoring' option is used, but the layer map file is not found. This is because either the -layerMap option is not specified or technology does not have the layer map file. Use a valid layer map file and then translate again.
INFO (XSTRM-273): Translation failed. '1' error(s) and '0' warning(s) found.

ERROR: Problem happened while processing strmout."

There are layer map files,

how and where to specify them in cadence virtuoso gui. Please guide.

Parents

Saumeek over 1 year ago
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Saumeek over 1 year ago
Cancel
Vote Up 0 Vote Down

Cancel

Children

RobMan over 1 year ago in reply to Saumeek

These are essentially options relating to stream out. Layer mapping and the enable coloring are available on the Pegasus 'Input' tab.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.