Stats

Locked Locked
Replies 4
Subscribers 125
Views 3961
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Diva LVS error display

Johh over 1 year ago

when i'am using diva lvs and hit the "error display" button，it doesn't response。And CIW message as follows:

*error* eval: unbound variable - ivLVSShowForm

*error* eval: unbound variable - ivLVSDisplayErrorForm

i'am a beginner，how can i solve this question, can someone help me

Parents

Andrew Beckett over 1 year ago

That sounds as if the Diva functionality is not being properly loaded, which is a bit odd. What IC sub-version are you using? This is reported in the Help->About menus in Virtuoso.

Regards,

Andrew
Cancel
Vote Up 0 Vote Down

Cancel
Johh over 1 year ago in reply to Andrew Beckett

I'am learning the tutorial from cmosedu.com.And the subversion of virtuoso is IC6.1.8-64b.500.34
Cancel
Vote Up 0 Vote Down

Cancel
Andrew Beckett over 1 year ago in reply to Johh

Which particular tutorial are you doing? Please give the link (although I don't really see why it should fail with a specific tutorial) - note, giving the URL will cause your post to be rejected as potential spam, so you'll need to appeal that when it gets rejected and then I can approve the post. I can't really go through all of the tutorials on the site you mentioned as it will take too long!

Regards,

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 1 year ago in reply to Johh

Which particular tutorial are you doing? Please give the link (although I don't really see why it should fail with a specific tutorial) - note, giving the URL will cause your post to be rejected as potential spam, so you'll need to appeal that when it gets rejected and then I can approve the post. I can't really go through all of the tutorials on the site you mentioned as it will take too long!

Regards,

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Children

Johh over 1 year ago in reply to Andrew Beckett

First of all thank you for your enthusiasm.And I did as follows:

1.set up the 'ncsu cdk' and '.bashrc' from the "quick start information",and the link is "cmosedu.com/.../remote_x.htm"
2.do the "tutorial 1" that "layout and simulation of a resistive volatage divider"，and the link is
"cmosedu.com/.../cadence_tutorial_1.htm"

Regards,
Johh
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.