• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Netlisting error when doing parametric sweep on transient...

Stats

  • Locked Locked
  • Replies 1
  • Subscribers 125
  • Views 2763
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Netlisting error when doing parametric sweep on transient simulation

Volker T
Volker T 10 months ago

Dear all,

I defined two design variables in ADE Assembler, say V1 and V2, that define the voltage 1 and voltage 2 of a "vpulse" voltage source in my schematic.

Then, I define V1 = 1.0, and V2 = 2.0, run a transient simulation, and everything is as expexcted. The source provides pulses between 1.0 V and 2.0 V.

Next, I set V1 = 1.0:0.5:1.5, thereby creating a parametric sweep with 1.0 V and 1.5 V for V1. I keep V2 at 2.0 V. Then the simulation fails, and all I get is "netl err" in my Output Expressions and an error message that the results directory does not exist and nothing can be plotted: This is reasonable, as the results directory is deleted on starting a new simulation, and as there is no simulation result, none of my output expressions can be plotted.

WARNING (OCN-6040): The specified directory does not exist, or the directory does not contain valid PSF results.
        Ensure that the path to the directory is correct and the directory has a logFile and PSF result files.
WARNING (ADE-1065): No simulation results are available.
ERROR (WIA-1175): Cannot plot waveform signals because no waveform data is available for plotting.
One of the possible reasons can be that 'Save' check box for these signals are not selected in the Outputs Setup pane. Ensure that these check boxes are selected before you run the simulation.

Normally, this kind of para,metric sweep is not a problem, I have done this many times before. There must be something special in THIS PARTICULAR test bench or simulator setup. The trouble is, I don't get any useful error messages.

Does anyone know what might be the problem here OR where to find useful information to investigate further (log files stored somewhere)? Thank you!

Regards,

Volker

P.S. Using Corners instead does not help either. Running it through all values by hand works, though.

  • Cancel
  • Volker T
    Volker T 10 months ago

    Solved. I simply ran out of storage space. Unfortunately, there were no messages pointing me to this issue.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information