Stats

Locked Locked
Replies 1
Subscribers 125
Views 328
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't display the result of Jee

Hi, everyone.
I'm trying to check the result of sampled jitter aftering running pnoise analyse.
After I choose Jee from the direct plot panel, there's no result appear but a warning message shown in the picture below.
Then I choose Add to Output , and still either the ADE explorer or the calculator can display the result.
I ran the pnoise analyse one month before and I can draw the phase noise figure with the integeral result on the end of the figure after clicking plot button on the direct plot panel.
But now I can't do this analyse again. I think I need some help.
Best regards.

Andrew Beckett 6 months ago

Please contact customer support (after logging in, use Case->Submit Case). We'll need to see your setup and data.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.