Stats

Replies 1
Subscribers 124
Views 525
Members are here 0

The drain and source is different direction in pex with different fingers of the same mos

dogman4 1 month ago

hi,friends

I have a mos tube with m = 1 and fingers = 2. When using calibre, the d and s potentials shown in the pex file are correct for one finger and opposite for the other, as follows:

PM0 vdd IN OUT vdd .......

PM0@2 OUT IN vdd vdd .......

Is there a way to make the two fingers consistent?

thanks advance

calibre:v2016.2_39.26

Parents

Andrew Beckett 1 month ago

Calibre is not a Cadence tool. You should ask this from Siemens EDA customer support or on one of their forums.

Andrew
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Andrew Beckett 1 month ago

Calibre is not a Cadence tool. You should ask this from Siemens EDA customer support or on one of their forums.

Andrew
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.