Stats

Locked Locked
Replies 3
Subscribers 144
Views 3430
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

skill code to change the direction of pin,and symbol of that pin also

SUBBHAREDDY over 16 years ago

I want to change the direction of pin from input to inout pin,and at the same time i want to change the symbol

of that pin also in schematic view.

Pls write a sample code for the above requirement.

Thanks and regards

Subbhareddy

Parents

Jack777 over 8 years ago

Hi Andrew,

I'd like to the same thing here, but on symbol pin. I followed your code, but stuck at "pin~>fig~>master=master", since there is not master properties. The code works fine on schematic.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Jack777 over 8 years ago

Hi Andrew,

I'd like to the same thing here, but on symbol pin. I followed your code, but stuck at "pin~>fig~>master=master", since there is not master properties. The code works fine on schematic.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.