Stats

  • Locked Locked
  • Replies 7
  • Subscribers 144
  • Views 16060
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Automatic placement of VIAs

Vignesh054

Hi,

  I want to place maximum possible numbers of VIA's whenever there is MET1, MET2 overlap in the design.

Please help me with the skil codel?

  Thanks,

Vignesh T K

Parents

  • BTW, Auto mode in Create Via in IC613 works with overlapping rectangles as well as paths/pathSegs (pathSegs are a new object which are used in the create wire command - which incidentally allows creation of 45-degree segments where both the centre line and edge vertices are on the manufacturing grid).

    Regards,

    Andrew.

Reply

  • BTW, Auto mode in Create Via in IC613 works with overlapping rectangles as well as paths/pathSegs (pathSegs are a new object which are used in the create wire command - which incidentally allows creation of 45-degree segments where both the centre line and edge vertices are on the manufacturing grid).

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.