• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC SKILL
  3. ADE simulation files -- error

Stats

  • Locked Locked
  • Replies 6
  • Subscribers 144
  • Views 3079
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADE simulation files -- error

Thodoros
Thodoros over 14 years ago

 Hello,

I am trying to assign a simulation file to a ADE run (ADE ->setup -> simulation files) which contains the simple that follows:

simulator lang=spectre
_vAddr\<3\> (Addr\<3\> 0) vsource val0=0 val1=0 period=500p width=250p type=pulse

 I have ic6.1.4 and when I execute "Netlist and Run" I get the following error:

 Error found by spectre during circuit read-in.
     ERROR (SFE-874): "/home/simop/simulation/sram_PCCA/spectre/schematic/netlist/stimuli/stem" 2: Unexpected operator "<".

What really happens is that at the ~/ ... /simulation/<design>/schematic/netlist/stimuli/ directory the copied stimuli file has errased the "\" character.

I really have to add that character and perform ADE ->Simulation ->Run in order to continue with the simulation.

Can I ovefrcome this?

Thanks,

Thodoros

  • Cancel
Parents
  • smthiid
    smthiid over 14 years ago

    Hello Andrew,

    I googled a lot to solve my question here http://www.cadence.com/Community/forums/p/18309/1260848.aspx#1260848, and found your post.  I think it may be helpful to use a vector file to generate the control signals for my 924 bits, but I don't know how.  I actually only need to set them to be either 0's or 1's, and I think if I can name them as [#bus<1:924>] and set a vector file it should work.  Could you please give me some guidelines?  Which manual should I refer to?

    Thanks,

    Tao

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • smthiid
    smthiid over 14 years ago

    Hello Andrew,

    I googled a lot to solve my question here http://www.cadence.com/Community/forums/p/18309/1260848.aspx#1260848, and found your post.  I think it may be helpful to use a vector file to generate the control signals for my 924 bits, but I don't know how.  I actually only need to set them to be either 0's or 1's, and I think if I can name them as [#bus<1:924>] and set a vector file it should work.  Could you please give me some guidelines?  Which manual should I refer to?

    Thanks,

    Tao

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information