• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC SKILL
  3. modify netlist but don't change the schematic in skill ...

Stats

  • Locked Locked
  • Replies 7
  • Subscribers 143
  • Views 3664
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

modify netlist but don't change the schematic in skill function

imagesensor123
imagesensor123 over 14 years ago

 Hi,

   i have a Vpulse source which works like a switch in the output terminal in my design, it  starts with the "0" voltage. In fact, my problem is that, i must get some information like "VoutMaxmum" at the beginning of the simulation, owing to the switch is closed at the beginning so it's impossible to get or retrive the VoutMaxmum . i have thought out a solution with some limitation, i used a parameter "startVoltage" and "endVoltage" to present the Vpulse parameters like" Voltage 0 and Voltage 1" (you can see it in the Vpulse CDF file), and use some function changing the startVoltage value so that we can let the switch keep opened at the beginning. but i think there should be a better way for this, can we do this by modifing the netlist? do you have some good idea?

replacing the Vpulse by Vdc at first-->run-->get VoutMaxmum , by the way, i don't want to change the schematic

Regards,

zfeng

  • Cancel
Parents
  • Andrew Beckett
    Andrew Beckett over 14 years ago

    There is no need to alter the "CDF Tool Filter" setting - that's only for the edit properties form to filter which properties are shown.

    If you want to get the value, simply do:

    inst~>P0

    or to set it:

    inst~>P0="new Value"

    Regards,

    Andrew.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Andrew Beckett
    Andrew Beckett over 14 years ago

    There is no need to alter the "CDF Tool Filter" setting - that's only for the edit properties form to filter which properties are shown.

    If you want to get the value, simply do:

    inst~>P0

    or to set it:

    inst~>P0="new Value"

    Regards,

    Andrew.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information