Stats

  • Locked Locked
  • Replies 17
  • Subscribers 145
  • Views 28742
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

pPar not works for intiger CDF parameters

Sarvani

 Hi all,

        Is pPar works for all CDF parameters? I need to pass intiger numbers (like no. of fingers) from top level to bottem level in schematic. But when I enter pPar(NF) through edit object properties options then it doesn't work's. How can I get this intiger values to bottom level? Let me know if any other set up is needed.

thankyou,

sarvani

Parents

  • Hi marcel,

                  I have been getting below warning message. I have NF(no. of fingers) cdf parameter which is an intiger type. When I enter pPar(NF) as default value through TOOLS~>cdf~>edit then below warning message which I am getting. I have pmos width and length cdf parameters (which is type of srtings) which works well in passing parameters. I dont know much about this cdf parameters. Let me know is there any set up is needed? 

    *ERROR* The 'Default Value' is not specified for the following component parameter(s): NF

    'Default Value' is a mandatory field for component parameters.

    These component parameters will not be added to the CDF.


    *WARNING* Effective CDF parameter 'NF', cell 'nmos_5V', library 'DIG_CELLS',

    'defValue' field must be specified.

     Thank you,

    Sarvani

Reply

  • Hi marcel,

                  I have been getting below warning message. I have NF(no. of fingers) cdf parameter which is an intiger type. When I enter pPar(NF) as default value through TOOLS~>cdf~>edit then below warning message which I am getting. I have pmos width and length cdf parameters (which is type of srtings) which works well in passing parameters. I dont know much about this cdf parameters. Let me know is there any set up is needed? 

    *ERROR* The 'Default Value' is not specified for the following component parameter(s): NF

    'Default Value' is a mandatory field for component parameters.

    These component parameters will not be added to the CDF.


    *WARNING* Effective CDF parameter 'NF', cell 'nmos_5V', library 'DIG_CELLS',

    'defValue' field must be specified.

     Thank you,

    Sarvani

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.