• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC SKILL
  3. Abstract Generator: How to configure to tool to extract...

Stats

  • Locked Locked
  • Replies 5
  • Subscribers 141
  • Views 15610
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Abstract Generator: How to configure to tool to extract layer with specific purpose

kb how
kb how over 10 years ago

Hi,

May i know is there a way to configure "Abstract Generator" to extract the cell based on layer purpose, instead of all metal layers?

I had searching through the documents and nothing was found. I created a simple test case and verified that tool will extract all metal with any purposes.

The reason is because i have layer m1 with multiple purpose, and some are mainly for reference purposes. I want the tool to generate only on drawing,pin only. Can this be done?

Thanks in advance

  • Cancel
Parents
  • skillUser
    skillUser over 10 years ago

    Hi How,

    I think you just have to specify the layer and purpose for each of the metal layers that you want to extract.  The documentation notes this:

    If you specify only a layer name instead of a layer-purpose pair in the Geometry Specification column, the abstract generator considers all the purposes on that layer except the Ignored Purpose(s).

    So, either on the form, or in the .abstractrc file you can specify the layer-purpose rather than just the layer.  There is "ExtractPinLayersSig" for those layers that are to be used for pins.  Hopefully this answers your question?

    Regards,

    Lawrence.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • skillUser
    skillUser over 10 years ago

    Hi How,

    I think you just have to specify the layer and purpose for each of the metal layers that you want to extract.  The documentation notes this:

    If you specify only a layer name instead of a layer-purpose pair in the Geometry Specification column, the abstract generator considers all the purposes on that layer except the Ignored Purpose(s).

    So, either on the form, or in the .abstractrc file you can specify the layer-purpose rather than just the layer.  There is "ExtractPinLayersSig" for those layers that are to be used for pins.  Hopefully this answers your question?

    Regards,

    Lawrence.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information