Stats

Locked Locked
Replies 5
Subscribers 141
Views 15617
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Abstract Generator: How to configure to tool to extract layer with specific purpose

Hi,

May i know is there a way to configure "Abstract Generator" to extract the cell based on layer purpose, instead of all metal layers?

I had searching through the documents and nothing was found. I created a simple test case and verified that tool will extract all metal with any purposes.

The reason is because i have layer m1 with multiple purpose, and some are mainly for reference purposes. I want the tool to generate only on drawing,pin only. Can this be done?

Thanks in advance

Parents

kb how over 10 years ago

Hi Lawrence, thanks a bunch. This works!!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

kb how over 10 years ago

Hi Lawrence, thanks a bunch. This works!!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.