Stats

Locked Locked
Replies 5
Subscribers 143
Views 1198
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[HELP] Deleting Terminal "X" during a design open

Hello ,

I generated a schematic pcell using SKILL code , The generation was successfull but whenever I open the design I get the following warnings :

Deleting the terminal "sub!", during a design open or synchronization operation, as it has no pin associated with itself.

I get these warnings for all terminals in the schematic . Any hint why I am getting these warnings ? Is it because I didn't assign any pin in my design ?

Thanks

Parents

Andrew Beckett over 10 years ago

Can you post the code (for the schematic PCell)? It's pretty hard to debug without seeing it. Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 10 years ago

Can you post the code (for the schematic PCell)? It's pretty hard to debug without seeing it. Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.