Stats

  • Locked Locked
  • Replies 3
  • Subscribers 143
  • Views 14138
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Abut using Skill

Abhishek Iyer

I have to generate a lot of test cases for MOS abutment.
So I have written a skill code to place mos devices with drain and source tied together in schematic (each schematic has 10 mos devices with varying widths in groups of 2 to test the abutment...  i.e. each schematic will test 5 abutment cases) and to create corresponding layout using lxGenFromSource.

Now I want to trigger abutment. Is there a way to do it using skill?

The abutment works perfectly using the UI mode. The abut function is  set up properly. Its just that I want to do the same through skill what I achieve through UI.

Regards
Abhishek

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.