Stats

  • Locked Locked
  • Replies 3
  • Subscribers 143
  • Views 13682
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Timeout a procedure within SKILL

mp133786

Hi,

Within a SKILL procedureA, I am calling another SKILL procedureB.  In a normal scenario, procedureB should finish within 20-30 seconds.  If I want to terminate the procedure execution after X minutes, how would I do that?  IpcBeginProcess starts a new process and I don't want that.  Is there a timeout type feature for a skill procedure call?  Thank you.

procedure( myProcedureA()

   myProcedureB() ; <<<< want to terminate the procedure if not done within some time limit.

) ; end myProcedureA

procedure( myProcedureB()

   ;; do bunch of stuff

   ;; stuff should be done within 20-30 seconds

   ;; Terminate the procedure if not done within some time limit.

) ; end myProcedureB

Parents
  • I have done this before in a procedure that had a while loop. In some cases it would be run on large sets of data and needed to stop. Basically I put a check in my loop to see if a pre-defined time limit had been exceeded.

    timeLimit = 30 ; seconds

    while( ...
    curTime=stringToTime(getCurrentTime())
    elapsedTime=curTime-startTime
    when(elapsedTime > timeLimit
    code to quit
    OR
    code to prompt user if they want to continue
    )
    )

    Since the above code takes a few small processing cycles, I actually only did that check once every 50 times through the loop using a counter and the modulus command.
    j=0 ; outside the loop

    j++ ; inside the loop
    when(integerp(timeLimit) && mod(j 50)==0
    myExceedTimeLimitCheck()

    I hope this helps.

    Derek
Reply
  • I have done this before in a procedure that had a while loop. In some cases it would be run on large sets of data and needed to stop. Basically I put a check in my loop to see if a pre-defined time limit had been exceeded.

    timeLimit = 30 ; seconds

    while( ...
    curTime=stringToTime(getCurrentTime())
    elapsedTime=curTime-startTime
    when(elapsedTime > timeLimit
    code to quit
    OR
    code to prompt user if they want to continue
    )
    )

    Since the above code takes a few small processing cycles, I actually only did that check once every 50 times through the loop using a counter and the modulus command.
    j=0 ; outside the loop

    j++ ; inside the loop
    when(integerp(timeLimit) && mod(j 50)==0
    myExceedTimeLimitCheck()

    I hope this helps.

    Derek
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.