Stats

Locked Locked
Replies 2
Subscribers 143
Views 1631
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Define "Spec" based on corner setup

Is it possible to specify the "Spec" based on the corner setup? Is there an easy solution here?

What I would like to have specify the "Spec" something like, if GM==1 then 30 elseif GM==5 then 27 else 22.

I know I can create separate tests for different corners and specify the "Spec" for each one differently. But, I am looking for something other than this.

Thanks a lot in advance.

Andrew Beckett over 4 years ago

You can go over the specification and use Right Mouse->Override Specifications which allows you to set different specs for different corners.

Does that do what you want?

Andrew
Cancel
Vote Up 0 Vote Down

Cancel
amitG22 over 4 years ago in reply to Andrew Beckett

Yes that is what I was looking for. Thanks a lot.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.