Stats

Locked Locked
Replies 5
Subscribers 143
Views 3591
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Showing list of history name and its notes for similar history name at ADE Assembler

HongJian over 1 year ago

(+) Virtuosity: Exploring Histories - Analog/Custom Design - Cadence Blogs - Cadence Community

This is taken from the blog post. Is it possible to do it at ADE Assembler level? (SKILL solution is welcomed too)

I need to run on ADE Assembler instead of ADE explorer for comparing variables/setup state.

Parents

Andrew Beckett over 1 year ago

You can see the notes as a tooltip in the history tab of the Data View assistant - is this what you want? My first rule is don't write SKILL for something that already exists (if it's close enough)!

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 1 year ago

You can see the notes as a tooltip in the history tab of the Data View assistant - is this what you want? My first rule is don't write SKILL for something that already exists (if it's close enough)!

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Children

HongJian 11 months ago in reply to Andrew Beckett

Hi, just a follow up, the notes that i keyed in inside the Specify History Name form is missing and I need to rekey the same note after the run is finished. is this expected?

the note is missing
Cancel
Vote Up 0 Vote Down

Cancel
Andrew Beckett 11 months ago in reply to HongJian

This appears to be a bug with the older way of setting the history name prior to simulation: envSetVal("adexl.historyNamePrefix" "showNameHistoryForm" 'boolean t)

There's a newer way in Assembler with a toolbar to set the history name. That however doesn't have the ability to set notes - that's Cadence Change Request #2696580 which is requesting this. I suspect the older and newer history name mechanisms are interfering with each other and the note setting part has broken (it's certainly broken in IC23.1 ISR9).

Andrew
Cancel
Vote Up 0 Vote Down

Cancel
HongJian 11 months ago in reply to Andrew Beckett

I see, so it is known bug. I will write the note after the run is launched then. Thanks a lot!
Cancel
Vote Up 0 Vote Down

Cancel
Andrew Beckett 11 months ago in reply to HongJian

No, it's not a known bug (as far as I am aware). I reproduced it, but I didn't find any reports of it. You should report it to customer support.

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.