Stats

  • Locked Locked
  • Replies 4
  • Subscribers 91
  • Views 13511
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

soc encounter output to Magic

Renee

I had problems when I exported the routing results from soc encounter to Magic. 

In the SoC encounter, after verifying the results, I saved the design as GDS, and read it into Magic. But it said that there were instances as control_VIA0 and control_VIA1, which I think were the generated vias instances. But I don't have these vias defined in Magic, so when I read the stream file in Magic, it said that it cannot find the cell control_VIA0 and control_VIA1.

Meanwhile, in the soc encounter, the wires indeed connected to the edge of the cell, but when it was imported into Magic, some wires extended over the edge of the cell, while some did not. I don't know why it happened.

Thanks in advance!

 

Renee

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.