Stats

  • Locked Locked
  • Replies 7
  • Subscribers 91
  • Views 14282
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Errors in pad fillers using AMS 0.35u technology (SOCE)

Mooty

Hi,

I'm using SOCE for P&R and I keep getting this spacing error with the pad fillers:

Pin of Cell IN0_5 & Blockage of Cell pfill_W_44

Actual:     0.7     Min:     0.8    bbox = (180.000, 1768.250) (180.700, 1772.550)

 I cannot seem to resolve it.  What could be the problem?

 

Parents

  • Hi,

    Thanks a lot for your help.

     The first case, however, is actually the connection between the power pads and the power ring.   This connection is necessary right?

    I have another problem now.

     

     

     Apparently, there are some  DRCs between the power stripe and the cells beside it.  The error seems related to the clock as all of the errors have the clock present.


Reply

  • Hi,

    Thanks a lot for your help.

     The first case, however, is actually the connection between the power pads and the power ring.   This connection is necessary right?

    I have another problem now.

     

     

     Apparently, there are some  DRCs between the power stripe and the cells beside it.  The error seems related to the clock as all of the errors have the clock present.


Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.