Stats

  • Locked Locked
  • Replies 7
  • Subscribers 91
  • Views 14510
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Errors in pad fillers using AMS 0.35u technology (SOCE)

Mooty

Hi,

I'm using SOCE for P&R and I keep getting this spacing error with the pad fillers:

Pin of Cell IN0_5 & Blockage of Cell pfill_W_44

Actual:     0.7     Min:     0.8    bbox = (180.000, 1768.250) (180.700, 1772.550)

 I cannot seem to resolve it.  What could be the problem?

 

Parents
  • Kari

     Mooty,

    You have a spacing violation between the m2 in the via on the C pin and the m2 bus on the left. (I think your nets are not displayed because you are in floorplan view instead of physical view.) Once you get the nets displayed, the error should be clear.

    - Kari 

Reply
  • Kari

     Mooty,

    You have a spacing violation between the m2 in the via on the C pin and the m2 bus on the left. (I think your nets are not displayed because you are in floorplan view instead of physical view.) Once you get the nets displayed, the error should be clear.

    - Kari 

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.