Stats

Locked Locked
Replies 12
Subscribers 93
Views 8584
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

encounter -error while loading design

**ERROR: (SOCLF-82): Macro "DFSECP1" obs coordinate y value 9.0740 isn't on manufacturing grid. It's likely result in placement/routing that can't be manufactured How could i solve this error?

Parents

Kari over 10 years ago

RGrid is the routing grid. since you don't route to filler cells, that's not a problem. i'm not even sure what pins you would see on fillers aside from the pwr/gnd rails.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Kari over 10 years ago

RGrid is the routing grid. since you don't route to filler cells, that's not a problem. i'm not even sure what pins you would see on fillers aside from the pwr/gnd rails.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.