HI ,can any once suggest me how to overcome or load calibre DRC violations on to Soce "4.2.2" older version is OK (4.1) no problem .cmd used :loadViolationReport -type Calibre -filename calibre.errit reports as can't read "designName": no such variablethanks in advice .
Hello,The proper syntax for loadViolationReport is "loadViolationReport -type -filename .
The first line in calibre.err file should be,
The deisgn name could be the name of the design/block for which the calibre was run. Units are GDSII units usually set to 1000.
In your case, you are missing this line. Hence the error. Hope this helps this issue. You may also want to try running “PVS” which is Cadence solution for DRC. PVS reads Calibre rule deck verbatim and generates output in Calibre format. Regards,Elvis