Stats

Locked Locked
Replies 3
Subscribers 91
Views 884
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Die-size resizing(using resize line) using encounter 8.1 has some problem...

Hi ,

In our current project we need to resize the die for various reasons. Initially when we tried to do that using 8.1 Version... we could observe that the origin is changing from (0,0) to some other value....

But this problem doesnt exist in Version 7.1USR2...... Does any one know what could be the reason for the same ????

Thanks & Regards,
Naadhan

Parents

NAADHAN over 16 years ago

Hi Kari... i normally use the ENC GUI ...and use the Resize FloorPlan option in the FloorPlan Menu.... there i use shift Based method...Inside which i give the co-ordinattes for resize line.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

NAADHAN over 16 years ago

Hi Kari... i normally use the ENC GUI ...and use the Resize FloorPlan option in the FloorPlan Menu.... there i use shift Based method...Inside which i give the co-ordinattes for resize line.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.