Stats

  • Locked Locked
  • Replies 1
  • Subscribers 90
  • Views 12957
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Widening witdh of wire at Macro Pin using encounter

KVBABU

 Hi all,

 

In my design , i have some macro's , whose pin width is more than the default width of routing. So, i wanted the nanorouter to route this using default width  and while making a hook-up to macro pin , the width has to made equal to width of pin.

It is possible to achive this using nanorouter. if so please provide   command or GUI option.

 

Regards,

K.Viswanadh Babu 

 

 

  •  I don't know of an automated way to do this, but I'm curious why it's even necessary. If you really need to do it, the "hard" way is to hand route out from these pins a little bit (which would make them SPECIALNETS since you're forcing a NONDEFAULT width), then let Nano take it from there.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.