Stats

Locked Locked
Replies 1
Subscribers 90
Views 13258
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

clearing multicycle path constrints

Hi, Is there any CTE command that can be used to clear all the multicycle path contrints applied to the design. Also the command report_path_exceptions can be used to report all the exceptions.Is there a way to control it to print only the multi_cylce_paths. Regards Vijay

Originally posted in cdnusers.org by mvvijay78

Parents

archive over 18 years ago

The 7.1 release will have some ability to reset path exceptions.

- Ed

Originally posted in cdnusers.org by ejm
Cancel
Vote Up 0 Vote Down

Cancel

Reply

archive over 18 years ago

The 7.1 release will have some ability to reset path exceptions.

- Ed

Originally posted in cdnusers.org by ejm
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.