Stats

  • Locked Locked
  • Replies 3
  • Subscribers 90
  • Views 13430
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to get area results in Micron

admin
Hi everyone.
While synthesizing a small design in RTL compiler i came across this problem. I want the actually physical area. But report area command gives me number of cells and their total area, without any unit.

I searched the mannuals and found this "get_attribute fplan_height/fplant_width design" command but this commands give me "no value". Does anyone of you have any clue how to get physical area? Total area and if possible width and height of the design.

I also used get_attribute with aspect_ratio and it gives me aspect ratio= 1.0000 (althought looking at the schematic i dont think that the aspect ratio is 1)

Thanks in advance.
Shami
Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.