Stats

  • Locked Locked
  • Replies 6
  • Subscribers 91
  • Views 15154
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to change use clock on nets?

spach

Hi,

     I used CTS to buffer signal nets in my design at place stage. once the buffering was over I loaded the actual CTS spec and proceed furthur but these nets r having use clock property. Now My design is fully routed, Can any one tell a procedure to change use clock property to signal for these nets. 

Regards,

suresh

Parents
  • spach

    Hi Bob.

              I inserted clock buffers on some clk nets using ecoAddRepeater, but the new nets after the buffer insertion r not getting the use clk property. can u please tell how i can replicate the clk property for new nets also. Also can u please explain how encounter usually assigns this clock property on nets. please reply as soon as possible.

    Regards,

    suresh

Reply
  • spach

    Hi Bob.

              I inserted clock buffers on some clk nets using ecoAddRepeater, but the new nets after the buffer insertion r not getting the use clk property. can u please tell how i can replicate the clk property for new nets also. Also can u please explain how encounter usually assigns this clock property on nets. please reply as soon as possible.

    Regards,

    suresh

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.