Stats

  • Locked Locked
  • Replies 6
  • Subscribers 91
  • Views 15154
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to change use clock on nets?

spach

Hi,

     I used CTS to buffer signal nets in my design at place stage. once the buffering was over I loaded the actual CTS spec and proceed furthur but these nets r having use clock property. Now My design is fully routed, Can any one tell a procedure to change use clock property to signal for these nets. 

Regards,

suresh

Parents
  • spach

    Hi Bob,

                   I loaded the clokspec and used the following cmd

    ckSynthesis -check -forceReconvergent -trace

    the property on the eco nets in the clk path not updated. but the report file after tracing contains these eco net names.

    can u please tell how to set clock propery on these nets? 

    Regards

    suresh 

Reply
  • spach

    Hi Bob,

                   I loaded the clokspec and used the following cmd

    ckSynthesis -check -forceReconvergent -trace

    the property on the eco nets in the clk path not updated. but the report file after tracing contains these eco net names.

    can u please tell how to set clock propery on these nets? 

    Regards

    suresh 

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.