Stats

  • Locked Locked
  • Replies 1
  • Subscribers 91
  • Views 18584
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Connecting multiple bits to same output bus in cadence schematic

roy83
Hi, I am building a digital system where i have to pass a bit of input-bus directly to the output bus, but cadence schematic composer gives an error when i try to do that. Error: Shorted terminals - memTerms "IN" & "A" thru signal "IN". Error: Shorted terminals - memTerms "A" & "IN" thru signal "IN". Is there a way to resolve this error . Thanks in Advance.
  • Tongju

    You may like to use a dummy device (a wire) to connect both pins. For example, cds_thru, which is  from the "basic" library that comes with Cadence schematic tool, may do the job very well.   Just double check to make sure you will be able to create the expected netlist from this type of schematic and also, it will not break your CAD flow (LVS check, especially). 

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.