Stats

Locked Locked
Replies 3
Subscribers 92
Views 14898
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SOC Encounter :: Layout Routing Issues

I am facing a problem with the layout generated by Encounter. I am unable to route the design properly. After setting up the Floorplan of the design when I place the Standard Cells, it also routes the metals and the metals are overlapped. Also it doesn't use the standard rules like using M1 Horizontal and M2 Vertical. I am not sure why it does so and how could I overcome this issue.

I am attaching a pic of the layout as well.

SOC Encounter Layout Issue

Parents

Anjana over 13 years ago

It seems like the VIA definitions are not proper in your LEF. Are you using the same LEF as you got from the front end ?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Anjana over 13 years ago

It seems like the VIA definitions are not proper in your LEF. Are you using the same LEF as you got from the front end ?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.