Stats

Locked Locked
Replies 4
Subscribers 91
Views 14926
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

E shaped floorplan

I am working on a chip that needs to be shaped like an inverted "E". I was trying out the rectilinear option as per what is mentioned in the user guide, but it doesnt seem to work. Basically two portions need to be cut out from the normally rectangular FP. I am using the gui.

What do you do when you need the shape of a floorplan in a shape other than a rectangle or a square ? .

Parents

Anjana over 13 years ago

That would be great,Bob !. Is there any restriction or reported error on doing a "setIoFlowFlag 1" , after the rectilinear floorplan is done and the netlist with IOs is read back in ?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Anjana over 13 years ago

That would be great,Bob !. Is there any restriction or reported error on doing a "setIoFlowFlag 1" , after the rectilinear floorplan is done and the netlist with IOs is read back in ?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.