Stats

Locked Locked
Replies 8
Subscribers 91
Views 14838
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Slotting problems

Hi,

1. I was interested in knowing how can we slot wide metal connects in our automated flow of encounter, I have found an option in place and route, its a guide file which is a text file but that is an option which is not viable.

2. How can I increase the width of the routing metals.

Thanks in advance

Parents

wally1 over 13 years ago

The DRC rules are defined in the technology LEF file.
In regards to Wire Groups you can enable them during addRing, addStripe and Wire Editing. Attached is a short video (Shockwave) demonstrating their use.
wire_groups_in_EDI.swf
Cancel
Vote Up 0 Vote Down

Cancel

Reply

wally1 over 13 years ago

The DRC rules are defined in the technology LEF file.
In regards to Wire Groups you can enable them during addRing, addStripe and Wire Editing. Attached is a short video (Shockwave) demonstrating their use.
wire_groups_in_EDI.swf
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.