Stats

Locked Locked
Replies 1
Subscribers 90
Views 14732
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

gds to def convertion in Virtuso layout editor

Hi All

Can Any one guide me how should i change the def units while saving the def.

My issue is in gds some of the pins are having the location like 8.715 but after saving the def, in the def file for the same pin the location is 8.71. how can i see the exact location as in the gds in def. in def file i observed like DEF UNITS 100 MICRONS i think we have to increase this def units to 1000 to get the exact pin locations as in the gds. But how can i change the def Units to 1000. or is there any other approch for this please help regording this issue.

Parents

Kari over 12 years ago

The def will take its units from the tech lef. Make sure the tech lef has the units you want to use, then def out.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Kari over 12 years ago

The def will take its units from the tech lef. Make sure the tech lef has the units you want to use, then def out.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.