Stats

Locked Locked
Replies 1
Subscribers 91
Views 12939
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

edis postRoute opt error (ENCOPT-306)

Amare over 13 years ago

Helllo,

When I use EDIS10.1 to run post route optimization, it reports an error (error message shown below) and edis quits.

**ERROR: (ENCOPT-306): Found placement violationsin postRoute mode

No more message about this issue. And I checked my design all cells are already placed.

Is anybody ever encountered this problem? How did you solve it?

Thanks a lot!

wally1 over 13 years ago

Run checkPlace to report the violations. There are likely cells overlapping each other. Try running refinePlace prior to routing to fix the violations.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.