Stats

  • Locked Locked
  • Replies 2
  • Subscribers 92
  • Views 13137
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

reporting the standardcells in between two talking flops

manu9

Hii everyone,

Can any one let me know if there is an option or command in the tool which can generate  all the cells in between two talking flops so that i can upsize,downsize only those set of cells or replace HVT with RVT or viceversa.

Thankyou

  • you have to report timing using the option -from launch flop -to capture flop then it will report all the datapath cells in the report.

    Basically you need to change cells based on the timing analysis

  •  Yes,

    We do change cells based on timing,but the reason why I want to replace them is to make them a strong drivers with steeper transitions(to prevent or minimise the effect of Xtalk)

    NOTE: we can do this only when power is not a major concern.

    Thank you

     

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.