Stats

Locked Locked
Replies 2
Subscribers 91
Views 13747
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Simulation of amplification circuit using ORCAD

Sunny13 over 11 years ago

Hi.

I'm not sure if this is the correct forum. In case its not, please direct me to the direct one.

Problem: I'm trying to simulate the amplication circuit in ORCAD using a AC power source and LM 566.

I'm not able to get the waveform in the simulation window.

I've attached the screenshot of the circuit also.

Could anyone please help me in this.

Thanks,

Sunny

oldmouldy over 11 years ago

I suspect that, at least part of the issue is that there is no PSpice model found for the LM566C, hence the "green" DRC marker.
Cancel
Vote Up 0 Vote Down

Cancel
Sunny13 over 11 years ago

Thanks for the reply.
Could you please guide me how to correct this since I'm a beginner in this.
If you require I can provide you the circuit file.

Regards
Sunny
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.