Stats

  • Locked Locked
  • Replies 2
  • Subscribers 92
  • Views 13651
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Specifying a new vertical cell pitch in EDI

socallayout

Hello,

Is there a way to change the (vertical, in this case) cell pitch being used in Encounter?  I need to increase the width of the pwr/gnd rails and was hoping to just increase the pitch of the standard cells.  I've searched the site and only found variations of the generateTracks command (which does not change the cell pitch, but the metal tracks).

  • MikeLW

    How about 'createRow -spacing y', perhaps preceded by 'deleteRow -all'?

  • socallayout

    Thank You!  Your tip on the createRow command did lead me to a final solution.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.