Stats

  • Locked Locked
  • Replies 0
  • Subscribers 91
  • Views 12271
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

power nets not connected to PAD M3

Sirpa

Hello,

I am using sroute command

sroute -connect { blockPin padPin padRing corePin floatingStripe } -layerChangeRange { M1(1) LB(9) } -blockPinTarget { nearestTarget } -padPinPortConnect { allPort oneGeom } -padPinTarget { nearestTarget } -deleteExistingRoutes -allowJogging 1 -crossoverViaLayerRange { M1(1) LB(9) } -area { 1076.874 1428.067 1190.36 1216.186 } -nets { VDD_CORE GNDS_CORE } -allowLayerChange 1 -targetViaLayerRange { M1(1) LB(9) } 

To connect Power and ground nets VDD_CORE and GNDS_CORE to respective PADs

The PG pins in pads are in M3 layer ( metal 3)  .

When looking at the innovus GUI  I can not see the M3  layer in PADS and looks that the the nets are NOT connected.

How can I get them connected?

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.