Stats

Locked Locked
Replies 1
Subscribers 92
Views 10779
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

how can i get the same result of timing analysis from EDI and Tempus?

i did P&R by EDI tool and cleared all timing violations in the timing reports

but when i did sta by tempus, there's lots of hold violations by negative slacks

is this diffrence come from just by the tool engine performance ? or are there some methods or options that i can get the same timing analysis results from the edi?

SIAware setting is true

plaese help me

Parents

DimoM over 3 years ago

Hi,
you might want to look up 'timing correlation' on support.cadence.com.
There are some articles that could help you further, e.g.
Innovus to Tempus Timing Correlation
Update Training: Tempus to Innovus Correlation

-Dimo
Cancel
Vote Up 0 Vote Down

Cancel

Reply

DimoM over 3 years ago

Hi,
you might want to look up 'timing correlation' on support.cadence.com.
There are some articles that could help you further, e.g.
Innovus to Tempus Timing Correlation
Update Training: Tempus to Innovus Correlation

-Dimo
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.