Stats

  • Locked Locked
  • Replies 0
  • Subscribers 96
  • Views 8668
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Correlated Corners

Ismat

I am designing an inverter and wanted to to do the corner simulation. From the documents I came to know about correlated corners. These are common Fet and common Feol. I see both corners are needed to successfully run the simulations and I get 25 corners instead of only  5. Your guidance would be highly appreciated.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.